Release Notes for ScioSense UFC Evaluation Software

v1.2.1 (December 13th, 2022)

+ New features / improvements:
	- "Load Project" now loads .ufc file contents that were exported individually (e.g. by export config)

v1.2.0 (September 16th, 2022)

+ New features / improvements:
	- Support for new PicoProg-Lite device interface
	- Option to select interface device when there are more than one connected
	- A confirmation dialog was added when trying to download FW data with an HSC_DIV_MODE value that is different from HSC_DIV (which may result in incorrectly displayed HS clock frequency)

+ Bugfixes:
	- Fixed displayed values for ideal HS clock period and calibration factor for 8 MHz oscillators
	- Fixed a rarely occurring crash when the device was reconnected during sleep mode
	- Corrected reset of storing options upon device change
	- Graphs window: Optimized handling of large sample amounts
	- Graphs window: fixed some drawing issues that caused flickering
	- Some minor visual fixes / typo corrections


v1.1.1 (February 28th, 2022)

+ New features / improvements:
	- Export and display measurement values when controlled by flow firmware

+ Bugfixes:
	- Fix delayed display of AM average and standard deviation when controlled by flow firmware


v1.1.0 (November 19th, 2021)

+ New features / improvements:
	- Configurations can now be fully created, saved and loaded even when no hardware is attached
	- There are now "projects" which contain all data, i.e. configration settings, firmware data, custom flags and custom CPU values in a single file
	- Firmware data was extended by custom factors
	- In firmware window, custom flags can now be defined; they can be observed on the Monitoring page
	- Firmware data table columns can be resized
	- Handling of firmware-controlled scenarios is improved
	- Extensive new firmware code examples demonstrate how to display results when the bootloader is active
	- A new "Expert Settings" window allows setting additional values for special usage that where inaccessible in prior versions
	- External windows like Graphs, Registers or Firmware retain values, so when closing and opening them again, the previous values are still there
	- Relevant "Not Used" and "Recommended" values are no longer set implicitly by the software but can be loaded and written when configured
	- Graphs window now supports up to 8 CPU values and their labeling is improved
	- Store data: additional option to store calculated CPU values
	- Better detection of removed chip state
	- Refresh option to manually check for chip type and state 
	- Restrict decimal display of CPU values calculated values
	- Windows like Graphs or Registers are restored to normal window state
	- Some visual and label / name improvements, especially on TOF results page
	- File dialogs now filter by all supported file types per default
	
+ Driver updates:
	- New and signed PicoProg driver for Windows 10
	
+ Bugfixes:
	- Fix for graphs window which stopped progressing when one of two identical values is removed
	- Fix for detecting MCT after System Reset when bootloader is active
	- Fix for storing data when MCM is set to different phases
	- Current state is flagged as dirty when FW is downloaded
	- Fix for option "System Reset and Start Measurement" in firmware window 
	- Fix for unintuitive difference display when less than 10 TOF values are evaluated


v1.0.2 (February 5th, 2021)

- TOF and amplitude DIFF values (deltas) are now signed, allowing negative values if the UP value is smaller than the DOWN value


v1.0.1 (December 7th, 2020)

- Fix for an issue where the displayed fire frequency value was incorrect


v1.0.0 (November 30th, 2020)

- First release version